Material
Safety Data Sheet
May be used to comply with
OSHA's Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements. |
U.S.
Department of Labor
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072 |
IDENTITY
(As Used on Label and List)
|
BRISTAR |
|
| Note: |
|
Blank
spaces are not permitted. If any item is not applicable, or
no information is available, the space must be marked to indicate
that. |
|
| Section I |
Manufacturer's
Name
|
ONODA CORPORATION |
|
Emergency
Telephone Number
|
03-5683-2026 JAPAN |
|
Address
(Number, Street, City, State, and ZIP Code
|
|
|
Telephone
Number for Information
|
03-3285-9268 JAPAN |
|
|
NO. 1-13,
TOYO, 4-CHOME, KOTO-KU,
TOKYO
135, JAPAN
|
Date
Prepared
|
FEBRUARY 23, 2000 |
|
| Section II - Hazardous Ingredients/Identity Information |
| Hazardous
Components (Specific Chemical Identity; Common Names(s)) |
OSHA
PEL |
ACGIH
TLV |
Other
Limits
Recommended |
%
(optional) |
|
|
A.
HAZARDOUS COMPONENTS : NONE |
|
|
B.
NON-HAZARDOUS CHEMICAL COMPOUNDS (% by weight) |
|
|
|
|
1)
Silicon Dioxide (SiO2) |
2
- 11 % |
|
|
2)
Aluminium Oxide (Al2O3) |
0.3
- 6 % |
|
|
3)
Ferric Oxide (Fe2O3) |
0.5
- 3 % |
|
|
4)
Calcium Oxide (CaO) |
77
- 96 % |
|
|
5)
Magnesium Oxide (MgO) |
0
- 2 % |
|
|
6)
Sulfur Trioxide (SO3) |
0.5
- 5 % |
|
|
|
|
Sulfonated
melamine (CAS NO.64787-97-9) or naphthalene-sulfonic acid polymer
with formaldehyde, sodium salt (CAS NO.9084-06-4) .... Approx.
1 % |
|
| Section
III - Physical/Chemical Characteristics |
Boiling
Point
|
Not
Applicable |
Specific
Gravity (H2O = 1)
|
3.21 |
Vapor
Pressure (mm Hg.)
|
Not
Applicable |
Melting
Point
|
1200oC |
Vapor
Density (AIR = 1)
|
Not
Applicable |
Evaporation
Rate (Butyl Acetate = 1)
|
Not
Applicable |
Solubility
in Water
|
Slight |
|
Appearance
and Odor
|
Gray Powder, No odor |
|
| Section IV - Fire and Explosion Hazard Data |
Flash
Point (Method Used)
|
Not Applicable |
|
Flamable
Limits
|
Not Applicable |
|
LEL |
UEL |
Extinguishing
Media
|
Not Applicable |
|
Special
Fire Fighting Procedures
|
Not Applicable |
|
|
Unusual
Fire and Explosion Hazards
|
When
the product is used incorrectly such as the use out of proper
tempurature range etc., blow-out shts will occur. |
|
| Section V - Reactivity Data |
| Stability |
Unstable |
|
Conditions
to Avoid |
| Stable |
X |
|
Incompatibility
(Materials to Avoid)
|
Water (Only storage) |
|
Hazardous
Decomposition or Byproducts
|
None |
|
Hazardous
Polymerization |
May
Occur |
|
Conditions
to Avoid |
| Will
Not Occur |
X |
|
| Section VI - Health Hazard Data |
EYE CONTACT : Avoid |
|
|
|
Health
Hazards (Acute and Chronic)
|
1) Skin and eye contact : Irritation, Burn
2) Inhalation and Ingestion : The same symptoms as getting cement
or quicklime will appear. |
|
| Carcinogenicity: |
|
IARC
Monographs?
|
Not Applicable |
|
OSHA
Regulated?
|
Not Applicable |
|
|
| |
Signs
and Symptoms of Exposure
|
Since the product is an alkali material, skin etc. will be irritated. |
|
Medical
Conditions Generally
Aggravated by Exposure
|
Skin and eyes will be irritated and will burn unless immediately
rinsed off. |
|
Emergency
and First Aid Procedures
|
If the skin comes in contact with the product, rinse it off
with clean water immediately.
If eyes come in contact with it, rinse it off with clean water
immediately, and consult with a doctor as soon as possible. |
|
| Section VII - Precautions for Safe Handling and Use |
|
Steps
to Be Taken in Case Material Is Released or Spilled
|
1) Gather the released or spilled product with a broom or
a shovel.
2) Mix it with a large amount of water.
3) Sprinkle it onto open ground.
|
|
Waste
Disposal Method
|
1) Mix it with a large amount of water.
2) Sprinkle it onto open ground. |
|
Precautions
to Be Taken in Handling and Storing
|
Store it under dry condition, and wear safety goggles for eye
protection, and use rubber gloves. |
|
Other
Precautions
|
When mixing the product with water, do not get close to holes
filled with the mixture of
the product and water to avoid any accident to be caused by
blown-out shots. |
|
| Section VIII - Control Measures |
Respiratory
Protection(Specify Type)
|
It is recommended to wear ordinary dust-proof mask. |
|
| Ventilation |
Local
Exhaust
|
Not Applicable |
|
|
Mechanical
(General)
|
Not Applicable |
|
|
|
Protective
Gloves
|
Ordinary
Rubber Gloves
|
Eye
Protection
|
Safety
Goggles
|
|
|
Other
Protective Clothing or Equipment
|
Not
Applicable
|
|
| Work/Hygienic
Practices |
Not
Applicable |
|
